End Stops

SharkBite End Stop 10mm
Disclaimer: All images are for illustrative purposes only.

Safely cap off a pipe temporarily or install permanently

SharkBite brass push-fit end stops are tough, withstanding high temperature and pressure. The brass push-fit end stop fitting is designed for capping off pipework termination points safely and securely.

Made from DZR brass its sleek design means they also look good in front of wall applications too. Using a simple push-fit action, SharkBite uses a stainless steel grab and O-Ring seal to provide a safe secure connection.

SharkBite is suitable for plastic pipe (with inserts) and copper pipe, and can be easily demounted and reused.

Features and benefits

  • Quick and easy to install in both wet or dry conditions
  • Repairs can be made in seconds, saving considerable time verses traditional pipe fittings
  • Heat/flux free installation is ideal for use where flame jointing is not permitted
  • No need for expensive tools
  • Quick and easy to demount
  • Instantly reusable time and time again
  • Incorporates in-built pipe guidance for superior O-Ring protection
  • Pre-lubricated O-Ring
  • Electronically continuous, meaning no further earth bonding is required
  • Made from low-leaded brass
  • Suitable for hot and cold and central heating systems
  • Compatible with plastic pipe (with inserts) and copper pipe


WRAS approved product
SKUDescriptionSize mmQuantity per bagAccreditations
SB0410SharkBite End Stop 10mm105
SB0415SharkBite End Stop 15mm1510
SB0422SharkBite End Stop 22mm225
SB0428SharkBite End Stop 28mm285