90° Tap Connectors

SharkBite 90° Tap Connector 15mm x half inch loose nut
Disclaimer: All images are for illustrative purposes only.

Fix to a tap or appliance via a 90° connection feed

SharkBite brass push-fit 90° tap connectors are tough, withstanding high temperature and pressure. The brass push-fit 90° tap connector fitting is designed for connecting pipework to fixture or appliance and comes complete with sealing washer.

Made from DZR brass its sleek design means they also look good in front of wall applications too. Using a simple push-fit action, SharkBite uses a stainless steel grab and O-Ring seal to provide a safe secure connection.

SharkBite is suitable for plastic pipe (with inserts) and copper pipe, and can be easily demounted and reused.

Features and benefits

  • Quick and easy to install in both wet or dry conditions
  • Repairs can be made in seconds, saving considerable time verses traditional pipe fittings
  • Heat/flux free installation is ideal for use where flame jointing is not permitted
  • No need for expensive tools
  • Quick and easy to demount
  • Instantly reusable time and time again
  • Incorporates in-built pipe guidance for superior O-Ring protection
  • Pre-lubricated O-Ring
  • Electronically continuous, meaning no further earth bonding is required
  • Made from low-leaded brass
  • Suitable for hot and cold and central heating systems
  • Compatible with plastic pipe (with inserts) and copper pipe


WRAS approved product
SKUDescriptionSize mmBSP ″Quantity per bagAccreditations
SB141515ESharkBite 90° Tap Connector 15mm × 1⁄2″ Loose Nut151⁄25