Do SharkBite Fittings Last? Here's What Causes Failures and How to Avoid Them

Do SharkBite fittings last? Yes, if you install them correctly.  

When installed properly, SharkBite push-to-connect fittings (also known as SharkBite Max) can last you at least 25 years, which is backed by our industry-leading warranty. SharkBite Max fittings are designed for secure, leak-free connections and are built with longevity in mind. Discover how to properly install push-to-connect fittings and get answers to common FAQs about their quality and longevity. 

4 Reasons SharkBite Fittings Leak & How to Avoid Them

️Experiencing a leak with a SharkBite Max fitting? In most cases, the issue can be traced back to one of three installation errors.

 1. Problem: Pipe wasn't fully inserted.

✅ Solution: Mark the correct insertion depth on the pipe and fully insert the fitting to that mark. Use the SharkBite Max Depth & Deburr Tool to measure and mark the depth. 

 2. Problem: Pipe wasn't properly prepared.

✅ Solution: Cut the pipe squarely and deburr it to remove rough edges and debris. Use PRO PEX Cutters when cutting PEX pipe and the SharkBite Max Depth & Deburr Tool to deburr any pipe type.  

 ️3. Problem: Pipe is pulling on the fitting connection.

✅ Solution: Properly support the pipe with HoldRite pipe supports to anchor the pipe so it can seat properly in the fitting.  

 4. Problem: Too many disconnections.

✅ Solution: SharkBite Max fittings are designed for permanent connections, but not repeated connection and disconnection. We recommend disconnecting fittings only once, otherwise you may have a loose connection. 

Proper Installation Steps

SharkBite keeps the connection process straightforward: cut, deburr and mark, push and done. Each step helps you confirm that the connection has been made correctly.  

1. Cut the pipe square  

Make a clean, straight cut and remove loose material. An angled or damaged pipe can interfere with the seal.  

2. Deburr and mark the pipe  

Deburr the pipe with the SharkBite Max Depth and Deburr Tool, then remove any debris. Use the tool to measure the correct insertion depth and mark it with a permanent marker. This mark is your most useful installation check since it shows exactly how far the pipe needs to go into the fitting.  

3. Push the pipe to the tube stop  

Push the fitting firmly onto the pipe with a slight twisting motion until the pipe reaches the internal stop. Check the insertion-depth mark to confirm that the pipe is fully seated.  

4. Check and test the connection  

Before closing a wall or finishing the project, turn the water back on and inspect the connection for leaks.

The Bottom Line

SharkBite fittings simplify permanent plumbing connections, but proper installation is the key to long-lasting, leak-free performance. These simple steps take the guesswork out of the process, helping you complete a secure repair with less hassle and greater confidence.

Cut the pipe square, deburr rough edges, and remove any debris. Mark the correct insertion depth, then push the pipe into the fitting until it reaches the tube stop. Finish by inspecting and testing the connection to confirm a secure, leak-free seal.

See below for common SharkBite fitting questions.